Abstract
Highly conducting and transparent aluminum doped zinc oxide (ZnO:Al) thin films have been deposited on polyimide substrate by r.f. magnetron sputtering at room temperature. The influence of sputter pressure and thickness on the structural, electrical, and optical properties of ZnO:Al films deposited on polyimide substrate is reported. The crystallinity and degree of orientation was increased by decreasing the sputter pressure. For higher sputtering pressures an increase on the resistivity was observed due to a decrease on the mobility and the carrier concentration. As the film thickness was increased, the crystallite sizes were increased, but the average transmittance in the wavelength range of the visible spectrum was decreased. The electrical performances of the ZnO:Al films deposited on glass substrates are slightly worse than the ones of the films deposited on polyimide substrates with same thickness. The lowest resistivity of 8.6×10-4 Ω cm can be obtained for films deposited on glass substrate with the thickness of 800 nm.
| Original language | English |
|---|---|
| Pages (from-to) | 512-518 |
| Number of pages | 7 |
| Journal | Journal of Electroceramics |
| Volume | 23 |
| Issue number | 2-4 |
| DOIs | |
| State | Published - Oct 2009 |
| Externally published | Yes |
Keywords
- Al-doped ZnO (ZnO:Al)
- Polymer substrate
- Solar cell
- Sputter pressure, thickness
- Sputtering
